What’s the difference between all the available pressure sensors and how to choose one? This is what you should consider.
Category: PCB Design
300W Stand Alone Stepper Motor Driver
To have a big microcontroller drive a motor control loop can be an issue, why not delegating to a smart … More
Stop. Doubt. Plan, then Draw: SEAM8 Test Board
How fast could you draw a 400 pin BGA board? 2-5 hours? How about 30 minutes? or 5…
When everything fails: 24h PCB design lesson
4A LDOs, 40x HDMIs, wire bondings & SLVS signals: what could possibly go wrong in one brave night?
DELTA V2I1, a stripped down prototype FE PCB for LHCb UT
A flexible 5 layer board with lots of caps and wire-bonding pads: LHCb UT’s front end PCB prototype.
32:1 CH Analog mux with 4 Ohm on-state resistance
Muxing signals up to 10MHz with 10kV ESD protection and full DIP-switch manual control.
Nadim Conti 